Senior Hardware & Firmware Engineer in startup Tel Aviv

- Electronics Board & System Design: Own schematic design and component selection for all proprietary boards. Design system-level wiring architecture and detailed technical drawings. - Embedded Firmware Development: Write and architect low-level C/C++ firmware infrastructure to control and interface sensors, multi-axis motors, high-precision components and lasers subsystems with the software. - Hands-on Board Bring-Up, QC & Troubleshooting: Act as the primary lab problem solver for board debugging, rework, and failure analysis. Establish QC procedures for newly received boards to support production. - DFM & Cost Optimization: Apply strict Design for Manufacturability (DFM) principles to optimize PCB layouts, streamline assembly, and aggressively reduce production and bill-of-materials (BOM) costs. - PCB Layout Management: Drive physical board layout design, Requirements: - Education: B.Sc. in Electrical Engineering with at least 5 years of experience - Hardware & Layout Expertise: 3+ years of experience in board design (mixed-signal, power management, microcontrollers) and PCB layout tools (e.g., Altium, OrCAD, KiCad). - Embedded Firmware Skills: Strong C/C++ programming skills for microcontrollers (STM32, ARM Cortex, etc.) and deep familiarity with hardware protocols (SPI, I2C, UART, CAN, USB). - Hands-on Capability: Excellent lab skills (soldering, prototyping, oscilloscope diagnostics) and a natural problem-solving mindset. - Proven DFM Focus: Demonstrated experience implementing DFM practices specifically targeted at price reduction, cost optimization, and yield improvement in production. This position is open to all candidates.